Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- CASE Ingredients Functions
- Technologies
- Product Families
Features & Benefits
- CASE Ingredients Features
Applications & Uses
- Markets
- Applications
- Compatible Polymers & Resins
- Coating Type
- Applications
Composites part manufacturing
Self-leveling floors
Solvent free | high solid coatings, gel coats etc.- Processing
Resin Infusion
Resin transfer moulding (RTM)
Properties
- Physical Form
- Appearance
- Clear liquid
- Typical Properties
Value Units Test Method / Conditions Color max. 30 AHPA ASTM D1209 | ASTM D 5386 Viscosity at 25°C 10 - 20 m Pas ASTM D2196 Density at 25°C 0.89 - 0.90 g/cm3 ISO 1183 Pot life (at 25°C for 100 g mix1) 90 - 120 Minutes ASTM D1726 Use level (With standard liquid epoxy resin of EEW 190) 22 PHR - Potential Tg by DSC 140 - 155 °C DIN 11357-2
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety
Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact and irritation, the resin should be washed off immediately with soap and warm
water. Avoid breathing vapors, mist or gas. Please refer to the SDS for detailed safety instructions.
Packaging & Availability
- Packaging Type
- Packaging
Lapox AH-411 is available in 1 kg HDPE bottles. Other packing may be considered on request.
Storage & Handling
- Storage & Handling
Lapox AH-411 has shelf-life of 2 years if stored in their original sealed containers. Hardener may crystallise if stored below 15°C. Crystallisation may be reversed completely by heating the material between 60°C and 70°C. It is recommended to use resin and hardener only when they are clear and free from cloudiness. Hardener may cause irritation to sensitive skins. If contact does occur then it should be washed off immediately with soap and warm water. Please refer to the Safety Data Sheet (SDS) for detailed instructions on storage and handling.
- Spills and disposal
In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or other suitable
material. Flush area with water to remove trace residue. Do not allow the product to reach the sewage system. Waste must be disposed of in accordance with federal, state or local
regulations, as applicable.