Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Overview
- ECP 552 EMI Shielding Nickel Acrylic Aerosol coating combines EMI shielding properties with a convenient method of application for prototype, design and touch-up work; it is specially formulated in order to prevent settling and to provide a homogeneous finish.
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
Properties
- Physical Properties
Value Units Test Method / Conditions Aerosol Pressure 55 - 60 / 4 psi / bar - Contents 400 ml - Coverage approx. 6 square feet - Drying Time (Full) 12 hours - Drying Time (Touch) 15 minutes - Recommended Dry Film Thickness 50 (2) micron (thou) - Shelf Life 12 Months - - Surface Resistivity (at 2 thou / 50 microns) 0.9 ohms/sq ASTM D257
Regulatory & Compliance
- Certifications & Compliance
Technical Details & Test Data
- Method of Use
Surface Preparation: All contaminants including mold release, grease and dirt must be removed. Mask areas that do not require spraying.
Mixing: Shake vigorously for a minimum of 2 minutes to evenly distribute contents. Spray a small area to check compatibility with the substrate.
Application: Operate in an upright position, spraying in light, even strokes from side to side to avoid flooding. Shake briefly at intervals during spraying. On completion, invert the aerosol and spray to clear the valve and nozzle. It is advised to clear any excess material from the nozzle at frequent intervals to prevent blockage. If the nozzle blocks, use a pin to clear the opening, or remove the nozzle and flush with Toluene, Xylene or MEK. Replace the nozzle taking care to point the opening away from you. Optimum shielding performance is normally achieved at 3 coats. It is advised to coat several thinner coats than try to coat heavily in one pass.
Safety & Health
- Precautions
- Pressurized container. Protect from sunlight and do not expose to temperature exceeding 50oC. Do not pierce or burn, even after use. Do not spray on an open flame or any incandescent material. Keep away from sources of ignition - No smoking.
- Use under well ventilated conditions: Contains nickel / xylene mix / toluene. Harmful by inhalation. Do not breathe vapor. In case of insufficient ventilation - wear suitable respiratory equipment, which must be used in accordance with the manufacturer’s instructions. For excessive vapor inhalation, remove to fresh air and summon medical attention.
- Avoid contact with skin and eyes: In case of skin contact, wash with soap and water, dry and apply work cream. Eye Contact - flush with water for at least 15 minutes and seek medical attention. If accidentally swallowed, summon medical attention.