TBA Protective Solutions ECP 535 Static Dissipative Coloured Acrylic Coating

Enhanced TDS

Chemical Family: Acrylics & Acrylates
Product Type: 1K (1 component) Coating
Technologies: Ready-to-Use Products
Product Families: Ready-to-Use Products — Paints & Coatings
Protective Coatings

Markets: Electrical & Electronics
Applications: Electrical & Electronics — Packaging & Assembly
Electronics Coatings
Application Area: Electrical Components
Application Method: Brush,
Spray

Physical Properties


	Value	Units	Test Method / Conditions
Density	1.1	g/cm³	-
Drying Time (Full)	12	hours	-
Drying Time (Touch)	20	minutes	-
Recommended Dry Film Thickness	50	micron	-
Static Decay	max. 2	seconds	IEC TC15
Surface Resistivity (at 2 thou / 50 microns)	109	ohms/sq	ASTM D257

Method of Use: Surface preparation: All contaminants must be removed from the surface. Mark areas that do not require coating. A suitable primer may be necessary on certain substrates such as polyethene polypropylene etc.

Mixing and application

Reduce 1:1 by volume with supplied thinners, conventional spray equipment should be used. A gun pressure of 35 psi is recommended. Two passes are normally required to give the optimum thickness and surface resistivity values.

Brush coating: Brush directly from the can.

Precautions

Highly Flammable - keep away from sources of ignition. No smoking. Keep away from heat, sparks, and open flames. Keep all containers closed when not in use.
Use under well-ventilated conditions, personal respiratory protection should be worn during spraying conditions. Such devices must be used in accordance with the manufacturer's instructions.
Avoid contact with skin, wear protective gloves and clothing. Wash thoroughly with soap and water after use. If accidentally swallowed, seek medical advice.