Crestapol® 1210 Urethane Acrylate Resin

• Low viscosity
• Rapid cure
• Excellent toughness
• No post cure required

This resin should be allowed to attain workshop temperature before use. It requires the addition of a catalyst and two accelerators (one in the partially pre-accelerated grade) to start the curing reaction.

N.B Catalyst and accelerators should not be mixed directly together, since they react with explosive violence.

The recommended catalyst is Trigonox 44B and the recommended accelerators are Accelerator G and dimethyl aniline (DMA). Please note DMA may not be required with Crestapol 1210A. The geltimes that can be achieved depend on the levels of accelerators and catalyst. Examples are shown in the tables below.
Pot Life

Table 1 - 2.0% Accelerator D¹ and 1.0% Trigonox 44B

Table 2 - 2.0% Accelerator D¹ and 1.5% Trigonox 44B

Table 3 - 2.0% Accelerator D¹ and 2.0% Trigonox 44B

Table 4 - 1.5% Trigonox 44B (not relevant for Crestapol 1210)

Accelerator D¹ - 10% solution of DMA (dimethyl amine) in styrene.
Accelerator G² - 1% solution of cobalt in styrene.
NB: Please note that without DMA the geltime to peak time may be significantly increased.

* With 2% Accelerator G², 2.0% Accelerator D¹ (Crestapol 1210 only), 1.5% Trigonox 44B at 20°C

** Made with 4 layers 450g/m² PB CSM