Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Key Attributes
- Dark gray, uniform and smooth ESD coating
- Quick-dry
- Strong adhesion with excellent flexibility
- Does not contain toluene, xylene or MEK
- Low VOC and HAP free
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Cure Method
- Recommended Preparation
Clean the substrate with Isopropyl Alcohol, MG #824, so the surface is free of oils, dust, and other residues.
Brush
Thinning is not required for most brush applications.
Manual Spray Guns
Use a standard fluid nozzle gun to spray the diluted paint. The settings listed below are recommendations; however, performance will vary with different brands:
LVMP HVLP Nozzle tip diameter 1.2–1.4 mm 1.2–1.4 mm Inlet pressure 5–15 psi 5–15 psi Air flow 10–15 SCFM 8.3 SCFM Air cap 5–10 psi 5–10 psi When using a pressure pot and agitator, keep the agitator at low mixing speed with air pressure of 20–50 psi. Use the lowest pressure necessary to keep the particles suspended.
Selective Coating
For higher volume applications, paint can be applied via selective coating equipment. Use a system with constant fluid recirculation to keep the particles from settling in the lines. A fluid nozzle ranging from 1.2 mm–1.4 mm diameter and 5–10 psi fluid pressure is recommended depending on nozzle size. Thin the paint to adjust the viscosity to the level appropriate for the valve being used.
Clean-up
Clean spray system and equipment with MEK or acetone, MG # 434.
Properties
- Physical Form
- Physical Properties
Value Units Test Method / Conditions Density 0.94 g/mL - - Typical Properties
Value Units Test Method / Conditions Viscosity (at 25 ˚C) 8.6 cP - Calculated VOC 423 g/L - - Cured Properties
Value Units Test Method / Conditions Surface Resistance (at 50 μm) 2.0 x 10⁸ Ω/sq - Service Temperature Range -40 to 120 ˚C - - Uncured Properties
Value Units Test Method / Conditions Percent Solids 17 % -
Regulatory & Compliance
- Certifications & Compliance
- Quality Standards
Technical Details & Test Data
- Cure Instructions
Allow to dry at room temperature for 24 hours, or cure in an oven at one of these time/temperature options:
Temperature 45 °C 65 °C 80 °C Time 1 h 30 min 10 min - Usage Parameters
Recoat Time 5 min Cure Times 24 h @ 22 ˚C 1 h @ 45 ˚C 30 min @ 65 ˚C 10 min @ 80 ˚C Recommended Film Thickness 50 μm Minimum Film Thickness 40 μm Theoretical Coverage @ 2 mil 26800 cm2/L
Packaging & Availability
- Packaging Type
- Packaging and Supporting Products
Cat. No. Packaging Net Volume Net Weight 844AR-900ML Can 850 mL 799 g 844AR-3.78L Can 3.60 L 3.38 kg
Storage & Handling
- Shelf Life
- 2 Years
- Storage
Store between -5 and 40 ˚C in a dry area, away from sunlight (see SDS).