Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Key Attributes
- Certified UL 94 V-0 (File# E203094)
- Maximum constant service temperature of 200 °C
- Fluoresces under UV-A light
- Excellent corrosion resistance
Applications & Uses
- Markets
- Applications
- Application Method
- Application Instructions
Recommended Preparation
Clean the substrate with Isopropyl Alcohol, MG #824, so the surface is free of oils, dust, and other residues.
Spray
- Shake the can vigorously.
- Spray a test pattern to ensure good flow quality.
- Tilt the board at 45° and spray a thin, even coat from a distance of 20–25 cm (8–10 in). Use spray-andrelease strokes with an even motion to avoid paint buildup in one spot. Start and end each stroke off the surface.
- Wait 3 min before applying another coat, to avoid trapping solvent.
- Rotate the board 90° and spray again to ensure good coverage.
- Apply additional coats until desired thickness is achieved (go to step 3).
- Let dry 10 min at room temperature before applying heat cure.
- After use, clear the nozzle by inverting the can and briefly spraying until clear propellant comes out.
Cure Instructions
Allow to dry at room temperature for 48 hours, or after letting sit for 10 minutes, cure the coating in an oven for 20 min @ 65 ˚C.
Properties
- Physical Form
- Physical Properties
Value Units Test Method / Conditions Density 0.81 g/mL - - Typical Properties
Value Units Test Method / Conditions Viscosity (at 25 ˚C) 6 cP - Calculated VOC 627 g/L - - Cured Properties
Value Units Test Method / Conditions Resistivity 1.2 x 10¹⁵ Ω·cm - Dielectric Strength 1 056 V/mil - Dielectric Withstand Voltage min. 1500 V - Dielectric Constant (at 1 MHz) 1.99 - - Dissipation Factor (at 1 MHz) 0.012 - - Glass Transition Temperature (Tg) 29 ˚C - CTE Prior Tg 275 ppm/˚C - Service Temperature Range -40 to 200 ˚C - - Uncured Properties
Value Units Test Method / Conditions Percent Solids 8.6 % -
Regulatory & Compliance
Technical Details & Test Data
- Usage Parameters
Dry Time To Handle (1 coat)
Dry Time To Handle (2 coats)8 min 15 min Minimum Recoat Time 3 min Recommended Film Thickness 25–75 μm Theoretical Coverage @ 25 μm 4200 cm2
Packaging & Availability
- Available Packaging
Cat. No. Packaging Net Volume Net Weight 422B-340G Aerosol 425 mL 340 g 422B-340GCA Aerosol 425 mL 340 g
Storage & Handling
- Shelf Life
- 5 Years
- Storage
Store between -5 and 40 ˚C in a in a dry area, away from sunlight .