Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Benefits
- Protects against oil, gasoline and hydrocarbon based fluids
- Will penetrate through existing solvent based acrylic sealers and cureand seal coatings
- Penetrates through acrylic sealed concrete
- Meets NCHRP 244 for penetrating sealer
- Siloxane to penetrate and protect concrete surfaces
- Silane for deep penetration of concrete
- Salt protection
- Freeze–Thaw protection
- Re-Seals previously Cure & Sealed Concrete
Applications & Uses
- Markets
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Application
- Cured Concrete: surface should be clean and dry. Use a 3000 psi power washer to clean the surface. Remove oil and grease spots with concrete cleaner degreaser. Allow 24 hours to dry before sealing.
- Surface temperature should be between 50˚ and 90˚F.
- Can be applied with a solvent-resistant pump sprayer, brush, or roller of the appropriate nap length. Cross rolling should be performed for all application methods.
- When applying over a cure & seal membrane, use a roller to even out the resin film after applying CSI Super Seal SB. Do not allow the material to puddle.
- After 3-5 minutes, move material that isn’t absorbed to more porous areas and apply additional material to areas that are light in color.
- Due to the low viscosity, care should be taken during roller application to avoid puddling. The substrate must be completely dry prior to application.
- Do not apply this material over waterborne resin coatings.
- Care should be taken to ensure even coverage rate.
Properties
- Soluble in
- Aromatic Petroleum Naphtha & Tert-Butyl Acetate.
- Typical Properties
Value Units Test Method / Conditions VOC Content max. 100 g/L VOC Standard Flash Point 40.0 °F - DOT UN1263/PAINT/3/PGII - - Solids Content 10.0 % -
Technical Details & Test Data
- Coverage Rates
Coverage Rates – Actual coverage may vary depending on the texture, age and condition of the concrete, the application method and other local conditions.
- Smooth Finish, Per Coat – Material usage, per coat, is approximately 300 square feet per gallon.
- Broom Finish, Per Coat – Material usage, per coat, is approximately 200 square feet per gallon.
- Exposed Aggregate Finish, Per Coat – Material usage, per coat, is approximately 100 square feet per gallon.
*Note: very porous surfaces may require two applications.
Packaging & Availability
- Packaging Type
- Package Size
CSI Super Seal SB is available in 1 gallon and 5 gallon pails.