Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Fillers Included
- Polymer Name
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
Properties
- Physical Properties
Value Units Test Method / Conditions Density (Dam) 1.16 g/cm3 ISO 1183 - Mechanical Properties
Value Units Test Method / Conditions Tensile Modulus (at 1 mm/min, Dam) 11000 MPa ISO 527 Tensile Strength (at Break, 5 mm/min, Dam) 140 MPa ISO 527 Tensile Elongation (at Break, 5 mm/min, Dam) 6.1 % ISO 527 Flexural Modulus (at 2 mm/min, Dam) 9500 MPa ISO 178 Flexural Stress (at 3.5% Strain, 2 mm/min, Dam) 165 MPa ISO 178 Notched Izod Impact Strength (at 23°C, 50% RH, Dam) 32 kJ/m2 ISO 180 Unnotched Izod Impact Strength (at 23°C, 50% RH, Dam) 106 kJ/m2 ISO 180 Notched Izod Impact Strength (at -30°C, Dam) 19 kJ/m2 ISO 180 Unnotched Izod Impact Strength (at -30°C, Dam) 91 kJ/m2 ISO 180 - Processing Parameters
Value Units Test Method / Conditions Drying Temperature 80 - 100 °C Desiccant Dryer Drying Time 6 - 8 hrs Desiccant Dryer Mould Temperature 35 °C - Melt Temperature 240 - 255 °C - - Processing Note
Under the recommended processing condition small quantities of decomposition product may be given off during processing. To preclude any risk to the health and well-being of the machine operatives, tolerance limits for the work environment must be ensured by the provision of efficient exhaust ventilation and fresh air at the workplace in accordance with the Safety Data Sheet. In order to prevent the partial decomposition of the polymer and the generation of volatile decomposition products, the prescribed processing temperatures should not be substantially exceeded. Since excessively high temperatures are generally the result of operator error or defects in the heating system, special care and controls are essential in these areas.