Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Carrier
- Chemical Family
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Specific Features
- Low viscosity
- Resistant to tracking and erosion
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Applications
- Arresters
- Cable Accessories
- Insulators
- Application Details
- POWERSIL® XLR® 630 A/B is the right choice for economical production of large articles like hollow core insulators with suitable mixing and dosing equipment. Because of its extreme low viscosity the use of a high-cost injection molding equipment is not necessary, but of course possible if wanted.
- Due to the outstanding electrical properties POWERSIL® XLR® 630 A/B is an insulating material for indoor as well as for outdoor use.
Properties
- Catalyst Properties
Value Units Test Method / Conditions Dynamic Viscosity (A+B, Shear rate 10 s⁻¹) 13000 mPa·s DIN EN ISO 3219 Kick-Off Temperature (A+B) 105 °C - Pot Life (A+B, at 23°C) 2 days - - Cured Properties
Value Units Test Method / Conditions Arc Resistance min. 300 seconds IEC 61621 Density 1.14 g/cm³ DIN EN ISO 1183-1 A Dielectric Strength (1mm sheet) 23 kV/mm IEC 60243-1 Dissipation Factor (tan δ, at 50Hz) 2 x 10⁻⁴ - IEC 62631-2-1 Elongation (at break) 450 % ISO 37 Type 1 Flammability FV-0 - IEC 60695-11-10 Permittivity (at 50Hz) 2.9 - IEC 62631-2-1 Shore Hardness A 35 - DIN ISO 48-4 Tear Strength 25 N/mm ASTM D 624 B Tensile Strength 7 N/mm² ISO 37 Type 1 Tracking Resistance 1A 4.5 - IEC 60587 Volume Resistivity 10¹⁵ Ohm-cm IEC 62631-3-1 - Uncured Properties
Value Units Test Method / Conditions Dynamic Viscosity (Component A, Shear rate 10 s⁻¹) 14000 mPa·s DIN EN ISO 3219 Dynamic Viscosity (Component B, Shear rate 10 s⁻¹) 12000 mPa·s DIN EN ISO 3219 Mix Ratio (A:B) 1:1 parts by weight - - Properties
- Ready-to-use, two-component system
- Extreme low viscosity as a liquid rubber
- Excellent processing with suitable mixing and dosing equipment (low pressure mold filling)
- Excellent dielectric properties
- Best suitable for outdoor applications (uv & weathering resistance, excellent hydrophobic properties)
- Note
Cure conditions: 5 min / 165 °C in press
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Packaging & Availability
- Country Availability
- Regional Availability
Storage & Handling
- Storage Information
Store especially in warm climate, storage of the material in an air-conditioned warehouse with cool (below 25°C) and dry conditions is mandatory.