Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Carrier
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Special Features
- Heat resistant
- Low viscosity
- Solvent-free
Applications & Uses
- Markets
- Applications
- Application Area
- Cure Method
- Applications
- Appliances Industry
- Automotive Electronics
- Automotive, Aerospace & Railway
- Bonding & Sealing
- Electrical Components
- Formed-In-Place-Gaskets (Wet Type)
- Industrial Assembly
- Ready-to-Use Silicone Sealants - General Applications
- Application Details
High temperature grade for bonding, sealing and potting for electric and electronic applications.
Processing
- ELASTOSIL® N288 shows good primerless adhesion to many substrates. We recommend to run preliminary tests to optimize conditions for the particular application.
Properties
- Cured Properties
Value Units Test Method / Conditions Density 1.09 g/cm³ DIN EN ISO 1183-1 A Elongation (at break, Type 3, 23°C, 2mm) 300 % ISO 37 Shore Hardness A 35 - DIN ISO 48-4 Tensile Strength (Type 3, at 23°C, 2mm) 3.5 N/mm² ISO 37 - Uncured Properties
Value Units Test Method / Conditions Curing Time (at 23°C, 50 %r.h) 2 - 2.5 mm/day - Density (at 23°C) 1.07 g/cm³ DIN EN ISO 2811-1 Dynamic Viscosity 65000 mPa·s Brookfield Skin Formating Time (at 23°C, 50% r.h) 50 minutes - - Properties
- Neutral-curing system (oxime)
- Low viscosity
- Excellent heat stability: permanent temperature espsure up to 200°C, peak temperatures up to 250°C
- Excellent primerless adhesion to many substrates
- Note
Curing conditions: 2 mm, 14 days storage at 23°C and 50% RH.
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Quality Standards
Safety & Health
- Safety Note
- During vulcanization of ELASTOSIL® N288, a total of 4% by weight of an oxime is being split off. These vapors should not be inhaled for long periods or in high concentration. Work areas should therefore be well ventilated.
- Contact of unvulcanized silicone rubber with eyes and mucous membranes must be avoided as this would cause irritation. However if it does happen, rinse the affected area thoroughly with water.
Packaging & Availability
- Country Availability
- Regional Availability