Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Carrier
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Special Features
- Flexible at low (-40 °C) and high temperatures (+180 °C)
- Solvent-free
Applications & Uses
- Markets
- Applications
- Cure Method
- Applications
- Automotive Electronics
- Measurement & Control, Sensor Technology
- Application Details
Multipurpose grade for bonding, sealing and potting e.g in electronic applications.
Processing
- ELASTOSIL® N10 TRANSPARENT is a one-part room temperature vulcanizing sealant that cures to a flexible silicone rubber on exposure to atmospheric moisture. Higher humidity accelerates skin formation and curing as well as elevated temperature. However temperature shall not exceed 50°C during cure.
- During the crosslinking process, some oxime byproduct is released. After about 25 minutes a dry skin is formed. After formation of a sufficiently thick skin, glued parts may be handled without destruction. ELASTOSIL® N10 shows good primerless adhesion to many substrates.
- We recommend to run preliminary tests to optimize conditions for the particular application. If removing of silicone rubber from machines or dispensing equipment is necessary, white spirit is recommended as a solvent.
- However, cleaning should take place before the rubber is fully cured. Afterwards only the use of mechanical forces in combination with a swelling solvent or the use of high temperatures of approximately 100°C will help to remove sealant residues.
Properties
- Color
- Cured Properties
Value Units Test Method / Conditions Density 1.03 g/cm³ DIN EN ISO 1183-1 A Elongation (at break, Type 3, 23°C, 2mm) 200 % ISO 37 Shore Hardness A 25 - DIN ISO 48-4 Tensile Strength (Type 3, at 23°C, 2mm) 1.5 N/mm² ISO 37 - Uncured Properties
Value Units Test Method / Conditions Density 1.02 g/cm³ DIN EN ISO 2811-1 Dynamic Viscosity (at 23°C, Shear rate 1 s⁻¹) 8000 mPa·s DIN EN ISO 3219 Dynamic Viscosity (at 23°C, Shear rate 25 s⁻¹) 7500 mPa·s DIN EN ISO 3219 Skin Formating Time (at 23°C, 50% r.h) 25 minutes - - Properties
- Low viscosity
- Non-thixotropic
- Note
Curing Conditions: 14 days at 23°C and 50% rel. humidity, 2 mm sheet, no post-curing.
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Safety & Health
- Safety Note
- During vulcanization of ELASTOSIL® N10 TRANSPARENT, a total of 4% by weight of an oxime is being split off. These vapors should not be inhaled for long periods or in high concentration. Work areas should therefore be well ventilated.
- Contact of unvulcanized silicone rubber with eyes and mucous membranes must be avoided as this would cause irritation. However if it does happen, rinse the affected area thoroughly with water.
Packaging & Availability
- Country Availability
- Regional Availability