Valagro SpA Radifarm

To avoid leaching of RADIFARM, minimize irrigations for the first few days after treatment. For best results, this product should be applied to the soil and not the foliage.
Note for Drip Irrigation Application: When using low volumes of water Radifarm can be mixed in directly and applied; however, when usinga large volume of water apply most of the water first and then apply RADIFARM toward the end of the irrigation cycle. For drip irrigation, emitters should be within 4 to 6 inches of the plant base. Note for Drench/ Transplant Solution Equipment Application: Avoid application of RADIFARM when the substrate is dry. Irrigate thoroughly prior to application of RADIFARM. Note for Immersion Application: Seedling flats should be immersed in the RADIFARM solution for approximately 1 to 2 minutes. For flat immersions, it is recommended to bring the soil to field capacity in the root zone prior to application.

DRIP / TRICKLE IRRIGATION: The specific injection equipment and irrigation system must conform to federal, state, and local regulations pertaining to the fertilization of plants
through irrigation system and should be calibrated accurately prior to any application. The irrigation system should be operated to achieve maximum distribution uniformity to
avoid plant injury and/ or ineffectiveness. For best results, apply RADIFARM toward the end of the irrigation cycle allowing for sufficient time for the product to be flushed out of
the entire irrigation system before turning off the irrigation water. Flush and clean all parts with water including any pumps, hoses or nozzles after use of this product.
 

RADIFARM will disperse in water with little agitation. Any residue in pails is water-soluble. Triple rinse and add contents to the spray tank. Do not reuse container.
TANK MIXES: Do not mix with pesticides or any other chemicals without a compatibility test. Any tank mixes should be discussed and/ or approved with your local distributor prior to mixing and application.