Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Polymer Name
- Technologies
- Product Families
- Coloring
Material is already pre-colored.
Features & Benefits
- Materials Features
- Features
Standard grade with adhesion to Polypropylene, low hardness; excellent processing.
Applications & Uses
- Markets
- Applications
- Compatible Polymers & Resins
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
- UNISOFT TPE™ ST-50A-BK-3-01 is a general grade intended for use in injection molding. Can be used for applications in the Electronic & Automotive industry.
- Injection Molding (preferable standard 2-component injection molding machine to get adhesion to substrate), Extrusion.
Properties
- Color
- Mechanical Properties
Value Units Test Method / Conditions Hardness 50 Shore A ASTM D - 2240 Specific Gravity 1.18 g/cc ASTM D - 792 Tensile Strength 5.0 Mpa ASTM D - 412 Elongation at Break 625.0 % ASTM D - 412 Molding Temperatures Rear 320 - 355 (160 - 180) °F(°C) - Molding Temperatures Front 355 - 395 (180 - 200) °F(°C) - Molding Temperatures Nozzle 395 - 410 (200 - 210) °F(°C) - Molding Temperatures Mold 85 - 150 (30 - 65) °F(°C) - - Shrinkage Properties
Unisoft TPE™ grades are anisotropic materials. Their shrinkage properties are higher in the flow direction, and the shrinkage in the cross -flow direction is less. Unisoft TPE™ ST-50A-BK-3-01 shows shrinkage values between 1.0– 2.9 %.
- Rheological Properties
Actual rheological data of Unisoft TPE™materials are shear dependence. Viscosity will decrease at higher shear rates, and should be considered during injection molding design and setup of processing conditions.
Storage & Handling
- Purging
Purge thoroughly before and after use of this product (e.g. Polypropylene with MFI between 0.5 – 2.5).
- Drying Time
Material is not hygroscopic and drying is only necessary if material was stored under moisture.