Superior Huntingdon Composites M8636

This continuous filament mat is designed for reinforcing laminates. This mat is characterized as having fast wet-through, good wet-out, moderate conformability, good surface smoothness and very high mat tensile strength.

ROLL-UP & TELESCOPING REQUIREMENTS
The mat is wound on a 4" (10.2 cm) inside diameter paper tube, having a single tube
with a length the same as the mat width with the following tolerances:

•  For rolls 68” (172.7 cm) and greater, the tube length tolerances are plus 0", minus 1/2" (-1.27 cm)
•  For rolls less than 68” (172.7 cm), the tube length tolerances are plus 0”, minus 1” (-2.54 cm)

*The mat will be so wound that the maximum length of mat telescoping will not exceed 1/4” (0.64 cm). Telescoping is described as the condition where successive wraps of mat are not perfectly aligned one upon the other, bringing about a concave effect on one end of the roll and a convex effect on the other. No tube will protrude past the product

WRAPPING
The rolls are wrapped in polyethylene.
Standard Packing Method
PACKAGING
The rolls are multiple packed, twelve (individual or common) rolls for widths less than or equal to 42” (106.68 cm) or six (individual or common) rolls for other widths up to 84”
(213.36 cm), on a 66” (167.64 cm) x 44” (111.76 cm) varying height pallet. Greater than 84” (213.36 cm) are on a 116” (294.6 cm) x 44” (111.76 cm) varying height pallet. Also,
may be heat treated or block.
PALLETIZATION
The rolls of mat will be palle􀆟zed with pallet stretch packaging.