Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Agrochemical Functions
- Technologies
- Product Families
Applications & Uses
- Markets
- Applications
- Applications
TOXIMUL 8000 is a 100% active nonionic surfactant used as an emulsifier in a variety of agricultural formulations.
Properties
- Formulation Type
- Physical Form
- Appearance
- Clear liquid (at 25°C)
- Soluble in
- Water, Xylene
- Insoluble in
- Kerosene
- Dispersible in
- Methanol
- Typical Properties
Value Units Test Method / Conditions Cloud Point (in 1% deionized water) 87 °C - Melt Range -30.80 to 32.95 ºC - Density (at 25°C) 1.03 g/ml - Melted Quantity (at 25ºC) 98.59 % - Flash Point min. 94 °C PMCC Flash Point Tester Moisture Content 0.2 % - pH (in 5% 1:1 IPA/H₂O) 5 - 7 - - Pour Point -28 °C - Regulated Volatile Organic Chemicals 0 % U.S. EPA Viscosity (at 25°C) 400 cPs - Viscosity (at 45°C) 200 cPs -
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- All components of TOXIMUL 8000 are listed on the following countries: United States (TSCA), Australia AICS), Canada (DSL), China (IECSC), Korea (ECL), Philippines (PICCS) and New Zealand (ZNIoC). It is the responsibility of the end user to review the chemical control regulations for each country.
- TOXIMUL 8000 is approved for use as an inert ingredient under U.S. EPA 40 CFR 180.960.
Technical Details & Test Data
- Melt Point Determination of TOXIMUL® 8000
- Rheology of TOXIMUL® 8000
Safety & Health
- Other Data DOT Classification
- Non-Hazardous
Packaging & Availability
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling TOXIMUL 8000. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling materials.
- Bulk Storage Information: Stainless steel and glass fiber-reinforced polyester tanks are recommended. Many oven-cured phenolic and epoxy/phenolic linings may also be used. Elevated storage temperature may be desirable to maintain ease of pumping. Temperatures up to 130°F (54°C) can be maintained for long periods of time without degradation of the product.
- TOXIMUL 8000 which has been stored in drums at temperatures below 75°F (24°C) may thicken. It can be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 130°F (54°C) are not recommended.
- Occupational exposure can occur primarily through skin contact or via inhalation of vapors and mists. Engineering controls, personal protective equipment, and other workplace practices should be used to control these exposures.