Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Name
- Agrochemical Functions
- Technologies
- Product Families
Features & Benefits
- Biodegradability
Based on the composition STEPAN 3109-6 is expected to be biodegradable.
Applications & Uses
- Markets
- Applications
- Applications
STEPAN 3109-6 can be used in a variety of agricultural formulations, including soluble concentrates (SL), water dispersible granules (WG), wettable powders (WP) and ready-to-use
(RTU).
Properties
- Formulation Type
- Physical Form
- Appearance
- Clear liquid (at 25°C)
- Soluble in
- Water, Methanol
- Insoluble in
- Kerosene
- Dispersible in
- Xylene
- Typical Properties
Value Units Test Method / Conditions Density (at 25°C) 0.998 g/ml - Flash Point min. 94 °C PMCC Flash Point Tester Moisture Content 30 % - pH (in 5% aqueous) 9 - - Pour Point 7.8 °C - Viscosity (at 25°C) 330 cPs -
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- All components of STEPAN 3109-6 are listed in the following countries; the registration number for the active ingredient is included in parentheses: United States (TSCA), Canada (DSL), Australia (AICS), Philippines (PICCS), Korea (ECL), China (IECSC), Japan (ENCS), Europe (EINECS), New Zealand.
- Approved for use under U.S. EPA 40 CFR 180.920, pre-harvest application.
Safety & Health
- Health Effects
STEPAN 3109-6 is slightly toxic dermal in rats (LD₅₀>2000 mg/kg) and is corrosive to eye and moderately irritated to skin when tested as is. The product is not a skin sensitizer.
- Other Data DOT Classification
- Non-Regulated
Packaging & Availability
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling STEPAN 3109-6. Contact with eyes and prolonged contact with skin should be avoided. Wash thoroughly after handling materials.
- Bulk Storage Information: Stainless steel and glass fiber-reinforced polyester tanks are recommended. Many oven-cured phenolic and epoxy/phenolic linings may also be used. Elevated storage temperature may be desirable to maintain ease of pumping. Temperatures up to 120°F (48°C) can be maintained without degradation of the product.
- STEPAN 3109-6 that has been stored in drums at low temperatures may thicken or solidify. Product may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 120°F (48°C) are not recommended.