Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Chemical Name
- Industrial Additives Functions
- CAS No.
- 68081-96-9
- EC No.
- 268-364-5
- Technologies
- Product Families
- Chemical Formula
(CH3)(CH2)11OSO3NH4
Features & Benefits
- Labeling Claims
- Industrial Additives Features
- Biodegradability
Product is biodegradable.
Applications & Uses
- Markets
- Applications
- Applicable Processes
- Applications
POLYSTEP B-7 is used in latex manufacture. It is useful in most polymer systems, especially styrene-butadiene or vinyl chloride. POLYSTEP B-7 can also be used in the manufacture of fine particle size acrylics and styrene-acrylics. Improved water resistance is often observed when using POLYSTEP B-7.
Properties
- Physical Form
- Appearance
- Clear liquid
- Typical Properties
Value Units Test Method / Conditions pH (in 10% aqueous solution) 6.5 - - Actives Content (EW 297) 29 % - Color (Transmittance at 410 nm) min. 85 % - Flash Point min. 94 °C - Unsulfated Matter 0.91 % - Ammonium Sulfate Content 0.5 % - Ammonium Chloride Content 0.22 % - Density 1.03 g/ml - Viscosity (at 25°C) 150 cPs - Critical Micelle Concentration (CMC) 136 mg/L - Surface Tension (at CMC) 25 dynes/cm - Regulated Volatile Organic Chemicals (Ethanol) 0 % U.S. EPA
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- All components of POLYSTEP B-7 are listed in the following countries; the registration numbers for the active ingredients are included in parentheses: Europe (EINECS 218-793-9), Japan (ENCS 2- 1679), Canada (DSL 2235-54-3) and Australia (AICS 2235-54-3). It is the responsibility of the formulator to review the chemical control regulations for each country where the end product is intended to be sold or used.
- POLYSTEP B-7 is available in Kosher grade.
Safety & Health
- Toxicity
POLYSTEP B-7 is slightly toxic orally (LD50 is 3-5.5 g/kg).and it causes severe skin and eye irritation at the 10% solution level.
Packaging & Availability
Storage & Handling
- Storage & Handling
Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling Handling POLYSTEP B-7. Contact with the eyes or nose, or prolonged skin contact should be avoided. It is recommended that POLYSTEP B-7 be stored in sealed containers and kept in a dry place between 27 and 38 °C (80 and 100 °F). If material is frozen it should be heated gently and stirred to ensure it is homogeneous before use.
Bulk Storage Information
POLYSTEP B-7 should be stored in 316 stainless steel or fiberglass with a corrosion resistant liner. Mild agitation is recommended while storing to maintain homogeneity. Material should be stored between 27 and 38 °C (80 and 100 °F). Use mild heat if needed avoiding the use of steam since it may impact product integrity. Recirculated warm water is recommended. Pumps, pipes and transfer lines should be 316 stainless steel.