Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Name
- Agrochemical Functions
- CAS No.
- 61791-00-2
- EC No.
- 500-150-1
- Technologies
- Product Families
Applications & Uses
- Markets
- Applications
- Applications
The product is an effective emulsifier and emulsifier blend component for pesticide concentrates. It is based on mixed hydrophobes and show good emulsification properties over a wide HLB range. This surfactants is relatively stable in alkaline and acidic media and can replace alcohol or alkyl phenol ethoxylates in many emulsifier formulations.
Properties
- Formulation Type
- Physical Form
- Appearance
- Amber liquid
- Soluble in
- Water, Methanol, Xylene
- Insoluble in
- Kerosene
- Stable in
- Alkaline and acidic media
- Typical Properties
Value Units Test Method / Conditions Density (at 20°C) 1.05 g/ml - Moisture Content max. 0.5 % - pH (in 1% Aqueous) 7 - - Viscosity (at 25°C) 350 cPs - Flash Point min. 94 °C - Cloud Point (in 1% in 1% NaCl) 53 °C - Pour Point 13 °C - HLB (Calculated) 13 - - Regulated Volatile Organic Chemicals (Ethanol) 0 % U.S. EPA
Regulatory & Compliance
- Chemical Inventories
- Clearances
NINEX MT-615 is approved for use in the following countries: United States (TSCA), Europe (NLP 500-150-1/Polymer Exempt), Canada (DSL), Australia (AICS), Philippines (PICCS), China (IECSC), New Zealand (NZloC), and Korea (ECL KE-15566). It is approved for use as inert ingredients under U.S. EPA 40 CFR 180.910, pre- and post-harvest applications and U.S. FDA 21 CFR 175.105, 176.210. It is the responsibility of the formulator to review the chemical control regulations for each country where the end product is intended to be sold or used.
Packaging & Availability
Storage & Handling
- Storage & Handling
Normal safety precautions (i.e., gloves and safety goggles) should be employed when handling NINEX MT surfactants. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling materials.
Bulk Storage Information
It is recommended that NINEX MT surfactants be stored in stainless steel and glass fiber-reinforced polyester tanks. Many oven-cured phenolic and epoxy/phenolic linings may also be used. Elevated storage temperatures may be desirable to maintain ease of pumping. Temperatures up to 130°F (54°C) can be maintained for long periods of time without degradation of the product. NINEX MT-615 which have been stored in drums at temperatures below 60°F (16°C) may thicken or solidify. The surfactants may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up.