Sharda Chlorimuron 25 WDG

Sharda Chlorimuron 25 WDG is a water dispersible granule herbicide to be mixed with water and applied post-emergence to control selective broadleaf weeds and yellow nutsedge in soybeans,peanuts, and specified non-crop areas.

Brand: Sharda Chlorimuron (1 products)

Functions: Herbicide

Application Technique: Aerial Application, Post-Emergence, Pre-Emergence, Sprayers

Enhanced TDS

Knowde-enriched technical product data sheet

Identification & Functionality

Agrochemical Functions
Technologies
Product Families
Active Ingredients
Active Ingredients %By Weight
Chlorimuron Ethyl Ethyl 2-[[[[(4-chloro-6-methoxypyrimidin-2-yl)amino]carbonyl]amino]sulfonyl]benzoate   25.0%
Other Ingredients 75.0%
Total 100.0%

*This product contains 0.0156 pounds of Chlorimuron Ethyl per ounce of product  

Applications & Uses

Markets
Applications
Applicable Crop
Application Technique
Product Use Direction

- Use clean water only to calibrate sprayers. Keep water away from the well site.
- Spray equipment must be checked and calibrated regularly.
- Dilute and agitate excess solution and apply at specified rates and/or uses listed on this label.
- Measure this product accurately.
- Triple-rinse the pesticide container after emptied, and add rinsate to the spray tank.
- Thoroughly clean all application equipment immediately after use and prior to spraying crops other than soybeans or peanuts.

Direction For Use

It is a violation of federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements

Agricultural Use Requirements

Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This Standard contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification, and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE) and rrestricted-entry interval. The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard.
Do not enter or allow worker entry into treated areas during the restricted-entry interval (REI) of 12 hours.
PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated such as plants, soil, or water is:
•     Coveralls
•     Chemical-resistant gloves made of any waterproof material
•     Shoes plus socks

Properties

Physical Form

Regulatory & Compliance

Safety & Health

Precautionary Statement

HAZARDS TO HUMANS AND DOMESTIC ANIMALS
CAUTION. May irritate eyes, nose, throat, and skin. May be harmful if absorbed through skin. Avoid breathing dust or spray mist. Avoid contact with skin, eyes, and clothing. Seek medical attention if irritation persists.

PERSONAL PROTECTIVE EQUIPMENT (PPE)
Some materials that are chemical resistant to this product are listed below. If you want more options follow the instructions for Category A on an EPA chemical resistance category selection chart.
Applicators and other handlers must wear:
•     Long-sleeved shirt and long pants
•     Chemical Resistant Gloves made of any water proof material such as polyethylene or polyvinyl chloride
•     Shoes plus socks
Follow manufacturer’s instructions for cleaning/maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.
ENGINEERING CONTROL STATEMENTS
When handlers use closed systems, enclosed cabs or aircraft in a manner that meets the requirements listed in the Worker Protection Standard (WPS) for agricultural pesticides [40 CFR Part 170 Section 170.240 (d)(4-6)], the handler PPE requirements may be reduced or modified as specified in the WPS. Important: If a closed system is being used and PPE is reduced, handlers must be provided all PPE specified in the section “Applicators and Other Handlers” and have such PPE immediately available for use in an emergency, such as a spill or equipment breakdown.

USER SAFETY RECOMMENDATIONS
USERS SHOULD:
•    Wash hands thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.
•     Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.
ENVIRONMENTAL HAZARDS
Do not apply directly to water, or to areas where surface water is present, or to intertidal areas below the mean high water mark. Do not contaminate water when cleaning equipment or
disposing of equipment washwater or rinsate. Do not apply where/when conditions favor runoff.

Storage & Handling

Storage And Disposal

Pesticide Storage: Store product in original container only. Do not contaminate water, other pesticides, fertilizer, food or feed in storage.
Pesticide Disposal: Do not contaminate water, food, or feed by disposal. Wastes resulting from the use of this product must be disposed of on site or at an approved waste disposal facility.
CONTAINER HANDLING: Refer to the Net Contents section of this product’s labeling for the applicable “Nonrefillable Container” or “Refillable Container” designation.
Nonrefillable Plastic and Metal Containers (Capacity Equal to or Less Than 50 Pounds): Nonrefillable container. Do not reuse or refill this container. Triple rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container 1/4 full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Then, for Plastic Containers, offer for recycling if available or puncture and dispose of in a sanitary landfill, or by incineration. Do not burn, unless allowed by state and local ordinances. For Metal Containers, offer for recycling if available or reconditioning if appropriate, or puncture and dispose of in a sanitary landfill, or by other procedures approved by state and local authorities

All Other Refillable Containers: Refillable container. Refilling Container: Refill this container with Sharda Chlorimuron 25 WDG herbicide containing Chlorimuron ethyl only. Do not reuse this container for any other purpose. Cleaning before refilling is the responsibility of the refiller. Prior to refilling, inspect carefully for damage such as cracks, punctures, abrasions, worn out threads and closure devices. If damage is found, do not use the container. Check for leaks after refilling and before transporting. If leaks are found, do not reuse or transport container.

Disposing of Container: Do not reuse this container for any other purpose other than refilling (see preceding). Cleaning the container before final disposal is the responsibility of the person disposing of the container. To clean the container before final disposal, use the following pressure rinsing procedure. Insert a lance fitted with a suitable tank cleaning nozzle into the container and ensure that the water spray thoroughly covers the top, bottom and all sides inside the container. The nozzle manufacturer generally provides instructions for the appropriate spray pressure, spray duration and/or spray volume. If the manufacturer’s instructions are not available, pressure rinse the container for at least 60 seconds using a minimum pressure of 30 PSI with a minimum rinse volume of 10% of the container volume. Drain, pour or pump rinsate into application equipment or rinsate collection system. Repeat this pressure rinsing procedure two more times. Then, for Plastic Containers, offer for recycling if available or puncture and dispose of in a sanitary landfill, or by incineration. Do not burn, unless allowed by state and local ordinances. For Metal Containers, offer for recycling if available or reconditioning if appropriate or puncture and dispose of in a sanitary landfill, or by other procedures approved by state and local authorities. Outer Foil Pouches of Water Soluble Packets (WSP): Nonrefillable container. Do not reuse or refill this container. Offer for recycling if available or, dispose of the empty outer foil pouch in the trash as long as WSP is unbroken. If the outer pouch contacts the formulated product in any way, the pouch must be triple rinsed with clean water. Add the rinsate to the spray tank and dispose of the outer pouch as described previously. Do not transport if this container is damaged or leaking.