Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Polymer Name
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Materials Features
Applications & Uses
- Markets
- Applications
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
Properties
- Color
- Mechanical Properties
Value Units Test Method / Conditions Tensile Stress (Yield, 50 mm/min) ¹¹ 22 MPa ISO 527 Tensile Strain (Yield, 50 mm/min) ¹¹ 20 % ISO 527 Tensile Strain (Break, 50 mm/min) ¹¹ min. 50 % ISO 527 Tensile Modulus (at 1 mm/min) ¹¹ 390 MPa ISO 527 Hardness (Shore D) ¹¹ 61 - ISO 868 - Physical Properties
Value Units Test Method / Conditions Density ¹¹ 1.01 g/cm³ ISO 1183 Moisture Absorption (at 23°C, 50% RH) ¹¹ 1.1 % ISO 62 Water Absorption (at 23°C, 24hrs) ¹¹ 0.7 % ISO 62-1 Mold Shrinkage (flow, 24 hrs) ᵍ ¹¹ 1.2 % ISO 294 Mold Shrinkage (xflow, 24 hrs) ᵍ ¹¹ 1.5 % ISO 294 - Thermal Properties
Value Units Test Method / Conditions Melting Temperature ¹¹ 172 °C ISO 11357-3 Vicat Softening Temperature (Rate B/50) ¹¹ 164 °C ISO 306 - Impact Properties
Value Units Test Method / Conditions Charpy Impact (at 23°C, Unnotch Edgew 80*10*4 sp=62mm) ¹¹ No break kJ/m² ISO 179/1eU Charpy Impact (at -30°C, Unnotch Edgew 80*10*4 sp=62mm) ¹¹ No break kJ/m² ISO 179/1eU Charpy Impact (at 23°C, V-notch Edgew 80*10*4 sp=62mm) ¹¹ 120 kJ/m² ISO 179/1eA Charpy Impact (at -30°C, V-notch Edgew 80*10*4 sp=62mm) ¹¹ 20 kJ/m² ISO 179/1eA - Injection Molding
Value Units Test Method / Conditions Melt Temperature ⁷ 260 °C - Mold Temperature ⁷ 164 °C - - Note
- ᵍ Measurements made from Laboratory test Coupon. Actual shrinkage may vary outside of range due to differences in processing conditions, equipment, part geometry and tool design. It is recommended that mold shrinkage studies be performed with surrogate or legacy tooling prior to cutting tools for new molded article.
- ⁷ Injection Molding parameters are only mentioned as general guidelines. These may not apply or may need adjustment in specific situations such as low shot sizes, large part molding, thin wall molding and gas-assist molding.
- ¹¹ The information stated on Technical Datasheets should be used as indicative only for material selection purposes and not be utilized as specification or used for part or tool design.
Packaging & Availability
- Regional Availability