Inland Coatings RC 1650 Acrylic Seam Compound

• RC 1650 should be applied only to clean, dry, sound surfaces free of loose particles or other foreign matter.
• Over metal surfaces that show signs of oxidation, rust should be removed by wire brushing if necessary after pressure washing.
• A primer is required over such areas, as well as over areas that may have existing caulking.

• RC 1650 may be applied by brushing or troweling.
• RST Seam Tape or RPM Polyester Mesh is recommended over cracks or bridges that exceed 1/16”.
• Apply at a rate of 50 wet mils maximum.
• Application should be suspended immediately and our technical service personnel contacted if the results being obtained are less than desirable.

Approx. 300 fasteners per gallon; 85 linear feet of seams at 4” wide.

• RC 1650 is a water-based acrylic seam compound that will freeze and become unusable at temperatures below 32ºF.
• Protect from freezing during shipment and storage.
• Do not store material at temperatures below 45ºF.
• Do not apply RC 1650 at temperatures below 50ºF or of there is a chance of temperatures falling below 32ºF within a 24-hour period.
• Do not apply RC 1650 over wet substrates or when inclement weather is imminent.

• Easy application
• Great adhesion
• Excellent solar reflectance

• Metal roofs and siding
• Mobile home and RV’s
• Composition roofs
• Built-up roofs
• Trucks and trailer tops
• Silos and grain elevators