IMCO Technologies 465 HIGH SOLIDS WATER REPELLENT SEALER

• Water-based clear - will not discolor substrate (note: 465 cannot be tinted)
• Odor-free and non-toxic
• Breathable
• Prolongs surface life
• Deep penetration and quick film formation
• Ultra-violet stable
• Stops intrusion of de-icing salts, acids and water
• Reduces chloride penetration

The 465 is designed to form a deeply penetrating water repellant seal on most alkaline surfaces including concrete flatwork andparking structures

Surface Preparation

All surfaces must be sound, clean and free of all contaminants that would prevent penetration. New concrete should be allowedto thoroughly cure before application. Older concrete should be washed with a high pressure washer and/or cleaning agents if there is build up from years of usage.

Surface may be slightly damp, however; an excess of moisture on the surface will impede penetration. 465 is supplied ready touse, no dilution is necessary and is best applied by airless sprayer with fan type spray nozzle. Clean up with water. Exercisecaution around glass as 465 will etch the glass. Clean with soapy water immediately. A test application is recommended on thesurface, using the same equipment as you would for the job, to ensure compatibility and to see if desired waterproofing resultswill be acceptable. This will also be useful in determining the final application rate and proper procedure.

Available in 20L pail and 200L drums. Coverage is dependent on porosity of the substrate, however a coverage of 20 to 40 SF/L can be expected on most common construction materials.