Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Additives Included
- Polymer Name
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Materials Features
- Product Modification
Product code nomenclature takes in to account selected primary features of a product. The suffix may indicate a primary additional functionality, however, further multiple modifications are almost always possible and may be agreed upon and specified prior to our technical and commercial offer. Such enhancements are a normal part of our service capability and they do not affect the general characteristics listed in technical datasheets.
Applications & Uses
- Markets
- Applications
- Composites End Use
- Plastics & Elastomers End Uses
- Drying
Space must be left between sheets to allow correct drying.
Properties
- Physical Form
- Mechanical Properties
Value Units Test Method / Conditions Tensile Modulus (23°C) 2000.0 MPa ISO 527 Yield Stress (23°C) 47.0 MPa ISO 527 Charpy (Notched, 23°C, 1eA) 45.0 KJ/m² ISO 179 Charpy (Notched, -30°C, 1eA) 20.0 KJ/m² ISO 179 - Typical Properties
Value Units Test Method / Conditions Density* 1.16 g/cm³ ISO 1183 UV Stabilisation (According to Customer Requirement) Optional - - Flammability Rating (Annex 6, 7, 8 Cert:: E3 118RII-02 6056*00) min. 1.5 mm ECE R118.02 - Thermal Properties
Value Units Test Method / Conditions VICAT Softening Point (B/50) 113.0 °C ISO 306 HDT-A (A 1.8MPa) 98.0 °C ISO 75 - Miscellaneous Properties
Value Units Test Method / Conditions Mould Shrinkage 0.5 - 0.7 % - Thermoforming Temperature 180 - 210 °C - - Notes
Unless otherwise stated, products are tested at a typical thickness of 4mm
* The density quoted should only be used as a guide. This value can change depending upon the type and quantity of pigments or additives used.
** Fire behavior values given by raw material supplier or by indicative test on raw material. Not intended as a specification
Regulatory & Compliance
- Certifications & Compliance
- Certification
This material is formulated and certified to meet the requirements for ECE R118.02 Annex 6, 7, 8.
Certification: E3 118RII-02 6056*00
Technical Details & Test Data
- Supplemental Information
Chemical Contact and cleaning
Reagent Chemical resistanceReagent Chemical resistanceAcetone Not recommendedBrake Fluid Not RecommendedAcid – (Weak) Good Butter Excellent Acid – (Strong) Good Coffee Excellent Alcohol Fair Detergent Excellent Anti-freeze Excellent Diesel Good Base (Weak) Excellent Foodstuffs Good Base (Strong) Excellent Lubricating Oil Good Petrol Good Chemical resistance is influenced by many factors, including concentration, temperature, exposure time and material stress. Therefore the data should only be used as a guide.
Most common mild soaps dissolved in warm water can be used to effectively clean general dirt and surface contaminants, but in all cases should be objectively tested. Abrasive products will damage the surface.
- Dimensional Tolerances
Standard tolerances are subject to the local standard tolerance set. Extra tolerance requirements may be possible on request and by special agreement.
Storage & Handling
- Storage
Long storage times in humid conditions may require a product to be dried, e.g. 80oC for 2 hours +1hr per additional mm of thickness.