Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Features
SC-454M-6 is designed for potting and encapsulation of electrical/electronics components that require the dissipation of heat and the high temperature properties and low stress of a silicone compound. The cured material may be knife-cut for replacement of components and new compound may be poured in place and cured to re-form tight seal. Thermally conductive silicone potting compound used to encapsulate power supplies and heat sinks for LED lighting.
Applications & Uses
- Markets
- Applications
- Application Area
- Cure Method
- Instruction for Use
Some filler settlement may occur during shipping and storage. Mix well the contents every time before removing material.
- To use, mix, at room temperature, 100 grams of SC- 454M-6 (A) with 3 to 5 grams of SC-454M-6 (B).
- Mix well until uniform in consistency and vacuum degasses.
- Cure as recommended achieving the desired properties.
- Typical cured properties were determined using recommended cure schedule. Some difference in properties may occur with other cure schedules.
Properties
- Typical Properties
Value Units Test Method / Conditions Mix Ratio by Weight (Silcast/Catalyst) 100/3 to 5 - - Mixed Viscocity (at 25°C) 4000 - 6000 cPs - Pot Life (500 grams at 25°C) 30 - 60 minutes - Recommended Cure (at 25°C) 24 hours - - Typical Cured Properties
Value Units Test Method / Conditions Specific Gravity 2.2 - - Hardness 70 Shore A - Thermal Conductivity 1.4 W/m °K - Tensile Strength 650 psi - Elongation 70 - 80 % - Service Temperature Range -65 to 250 °C - Coefficient of Linear Thermal Expansion (-55°C to 25°C) 150 10^-6/°C - Dielectric Strength (3 mm thick) 540 Volts/mil - Dielectric Constant (at 1 kHz) 5.8 - - Dissipation Factor (at 1 kHz) 0.01 - - Volume Resistivity 6x10^14 Ω-cm -
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Warning
Although the system contains low volatility materials, care should be taken in handling. Adequate ventilation of workplace and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention.
Storage & Handling
- Shelf Life
The shelf life of these materials is six months when stored in unopened containers at an average temperature of 25°C.