Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Product Features
A clear, room temperature cure silicone with low viscosity allows for flow around complex parts providing electrical insulation and shock resistance
Applications & Uses
- Markets
- Applications
- Application Area
- Cure Method
- Typical Application
Potting and encapsulating of:
- Equipment modules
- Power supplies, relays and amplifiers
- Transformers, coils and ferrite cores
- Fiber optic waveguide coatings
- Encapsulation of circuit boards
- Instruction for Use
- Weigh each 100 grams of PART-A to 100 grams of Catalyst PART-B.
- Mix until uniform. Scrape the sides and bottom of container repeatedly during mixing.
- Apply to clean bonding surfaces and cure as recommended to achieve the desired properties.
- Typical cured properties were determined using recommended cure schedule. Some difference in properties may occur with the alternate or other cure schedules.
- Industrial Usage
Practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
Properties
- Color
- Typical Properties
Value Units Test Method / Conditions Mix Ratio by Weight (PART A/PART B) 100/100 - - Mixed Viscocity (at 25°C) 300 - 400 cPs - Pot Life (100 grams at 25°C) 20 - 30 minutes - Cure Option (at 25°C) 24 hours - Cure Option (at 65°C) 3 hours - Cure Option (at 100°C) 1 hours - Cure Option (at 150°C) 30 minutes - - Typical Cured Properties
Value Units Test Method / Conditions Specific Gravity 1.02 - - Hardness 23 Shore A - Refractive Index 1.41 - - Service Temperature Range -55 to 200 °C - Thermal Conductivity 0.18 W/m °K - Tensile Strength 970 psi - Elongation min. 100 % - Dielectric Constant (at 1 kHz) 2.6 - - Dissipation Factor (at 1 kHz) 0.001 - - Volume Resistivity 2x10^15 Ω-cm - Flammability Self-extinguishing - - - Key Performance Properties
- Convenient 1:1 mixing ratio for use in automatic dispensing equipment or hand mixing
- Low viscosity which allows for ease of flow around complex parts, providing electrical insulation and shock resistance
- Contains no solvents
- Non-yellowing catalyst system
- The chemical composition provides hydrolytic stability and reversion resistance
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Warning
Adequate ventilation of workplace and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention.
Packaging & Availability
- Available Packaging
2 parts Kit - Packaged in Pint, Quart, Gallon, and 5- Gallon size.