Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Markets
- Applications
- Application Area
- Instruction for Use
Stir well the contents of each container every time before removing material. If the contents are hard or lumpy, warm to 80°C and mix thoroughly before removing material.
1. Weigh each 100 grams of EC-1006 to 12 grams of Hardener EH-24.
2. Mix until uniform. Scrape the sides and bottom of container repeatedly during mixing.
3. Apply to clean bonding surfaces and cure as recommended to achieve the desired properties.
4. Typical cured properties were determined using recommended cure schedule. Some difference in properties may occur with the alternate or other cure schedules.- Industrial Usage
Practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
- Product Applications
General purpose epoxy encapsulating material. Designed for potting small or large electronic components.
Properties
- Color
- Typical Properties
Value Units Test Method / Conditions Mix Ratio by Weight (Resin/Hardener) 100/16 - - EC-1006 Viscosity (at 25°C) 14000 - 18000 cPs - Mixed Viscocity (at 25°C) 1400 - 1800 cPs - Pot Life (at 25°C, 100g) 2 hours - Recommended Cure (at 25°C) 2 hours - Recommended Cure (at 100°C) 1 hours - Alternate Cure (at 25°C) 24 - 48 hours - - Typical Cured Properties
Value Units Test Method / Conditions Specific Gravity 1.58 - - Hardness 89 Shore D - Linear Shrinkage 0.31 % - Water Absorption (24 hr at Room Temperature) 0.09 % - Thermal Conductivity 0.35 W/m °K - Glass Transition Temperature (Tg) 78 °C - Dielectric Strength 480 Volts/mil - Dielectric Constant (at 1 kHz) 2.8 - - Dielectric Constant (at 1 kHz) 4.8 - - Dielectric Constant (at 1 MHz) 2.3 - - Volume Resistivity 1x10^14 Ω-cm - Volume Resistivity 3x10^15 Ω-cm - Coefficient of Thermal Expansion (Below Tg) 39 10^-6/°C - Coefficient of Thermal Expansion (Above Tg) 190 10^-6/°C - Flexural Strength 14100 psi - Flexural Modulus 9x10^5 psi - Dielectrie Strength 460 Volts/mil - Dissipation Factor (at 1 kHz) 0.014 - - Dissipation Factor (at 1 kHz) 0.14 - -
Safety & Health
- Warning
Adequate ventilation of workplace and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention.
Packaging & Availability
- Available Packaging
2 parts Kit - Packaged in Pint, Quart, Gallon, and 5- Gallon size.