Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Applications
- Compatible Substrates & Surfaces
- Cure Method
- Instructions for Use
- To use, mix, at room temperature, 100 parts by weight of PART A with 35 parts by weight of Part B. Mix until uniform. Vacuum degas the mixture to remove entrapped air for best results. Apply as needed.
- Use recommended cure schedule to achieve best performance. Typical cured properties were determined using recommended cure schedule. Some difference in properties may occur with the alternate or other cure schedules.
Properties
- Typical Cured Properties
Value Units Test Method / Conditions Specific Gravity 1.1 - - Hardness 79 Shore D - Water Absorption (7days Submersion at 25°C) 0.8 % - Lap Shear Strength to Aluminium 2100 psi - Flexural Strength (Yield) 13900 psi - Flexural Modulus (Yield) 4.4x10⁵ psi - Maximum Service Temperature Range (Continuous) 150 °C - Maximum Service Temperature Range (Intermittent) * 200 °C - Glass Transition Temperature (Tg) 60 °C - Coefficient of Linear Thermal Expansion (From -60°C to 25°C) 85 10⁻⁶/°C - Dielectric Constant (at 1 kHz) 3.9 - - Dissipation Factor (at 1 kHz) 0.02 - - Volume Resistivity 6x10¹⁵ ohm-cm - Refractive Index (at 25°C, 589nm) 1.512 - - - Handling Properties
Value Units Test Method / Conditions Epoxibond Part A - - Hardener Part B - - Mix Ratio by Weight (Resin/Hardener) 100/35 - - Mixed Viscosity (at 25°C) 200 - 300 cps - Pot Life (at 25°C, 100 grams) min. 8 hours - - Note
Typical Cured Properties After Recommended Cure : Tested at 25°C unless otherwise indicated
Regulatory & Compliance
- Certifications & Compliance
Technical Details & Test Data
- Curing Information
- Recommended Cure : 3 hr at 80°C
- Alternate Cure : 3 days at 25°C
- Frozen Adhesive
Thaw premixed frozen adhesive at room temperature for 5-10 minutes. Dispense adhesive and cure at recommended schedules.
Safety & Health
- Safety Information
- For Industrial Use Only : Practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
- Warning : Although the system contains low volatility materials, care should be taken in handling. Adequate ventilation of work place and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention. Refer to Material Safety Data Sheet for additional health and safety information.
Packaging & Availability
- Availability
- 2 parts Kit : Packaged Gallon, and 5-Gallon size.
- Premixed and frozen : Packaged in 3cc, 5cc, 10cc and 30cc disposable syringes and ship in dry ice at -80°C.