Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- CASE Ingredients Functions
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- CASE Ingredients Features
Applications & Uses
- Markets
- Applications
- Compatible Polymers & Resins
- Adhesive & Sealant Type
- Coating Type
- Applications
- Encapsulation or Embedding
- Bar Top Epoxy
- Resin Jewelry
- Resin Castings
- Molding Resin
- Art, Hobby, Craft Resin
- High-Build Coatings
- Mass Castings (SLOW only)
- Application Method
APPLICATION TIPS:
- When working at higher temperatures, make smaller pours to avoid excessive exotherm. Epoxy cures at lower temperatures.
- Small castings will benefit from a post-cure of 100° F (38°C) for 24 hours to assure full cure.
- For best results, measure the two components by weight within 5% of the recommended mix ratio.
- Always mix product for at least two minutes, scraping the container to ensure complete mixing.
- Use products in a controlled environment. Avoid high humidity and cold temperatures.
- Amine blush, a by-product of the curing process, appears as a wax-like film cured epoxy and is more noticeable in cool, moist conditions. It can clog sandpaper and inhibit subsequent bonding. Blush is water-soluble and easily removed with clean water (not solvent) and an abrasive pad.
- For good adhesion, epoxy bonding surfaces should be clean, dry, and sanded.
- If unfamiliar with the product, create smaller test samples before starting a larger-scale project.
Properties
- Physical Form
- Typical Properties
Value Units Test Method / Conditions Tensile Modulus 448000 Psi ASTM D638 Tensile Strength 8140 Psi ASTM D638 Elongation 6 % ASTM D638 Flexural Modulus 390000 Psi ASTM D790 Flexural Strength 11850 Psi ASTM D790 Compression Strength 12380 Psi ASTM D695 Tg Ultimate 123 °F DSC, midpoint Hardness 70 - 80 - Shore D Mix Ratio (by volume) 2:1 - - Mix Ratio (by weight) 100:43:00 - - Viscosity A at 77°F 2160 - - Viscosity B at 77°F 30 - - Viscosity Mixed at 77°F 370 - - Component Density (Specific Density at 77°F, Resin) 1.13 - - Component Density (Specific Density at 77°F, Hardener) 0.98 - - Mixed Density (Specific Density at 77°F) 1.09 - - Pot Life (Specific Density at 77°F) 90 mins - Tack Free Time (at 95°F/35°C) 24 hrs - Recommended Full Cure at 77°F, Post Cure Recommended 7 days - VOC Content 0.08 lbs/gal ASTM D2369 Mixed Biobased Carbon Content 20 % ASTM D6866
Regulatory & Compliance
- Certifications & Compliance