Collano FL 330

Application area and materials

For veneering as well as general carpentry work. For high-quality wood bonding in furniture and interior construction, veneer and laminate bonding, joint and construction bonding (body, table, chair, window, etc.), veneering of cement-bonded chipboard and gypsum plasterboard. For cold or hot pressing and high-frequency bonding.

Application data

The curing behavior of PVAc dispersions depends on the absorbency and strength of the adherends, as well as the ambient temperature and press temperature. The specified figures are guideline values and are based on results of tests on precision bonds made under standard climatic conditions (20°C and 65% relative humidity). Deviations are possible depending on the type of use.

Application

It is essential that the surfaces are clean and grease-free in order to provide the best adhesion and quality of join. In case of long run times of the application system, the adhesive can be restored to normal consistency by adding 5% water. If required, the adhesive may be colored using a water-soluble wood stain or Pintasol/Mixol. Wait at least 24 hours before carrying out surface treatments. Apply the adhesive to one of the surfaces, or to both surfaces for hardwoods and exotic woods, and for slotted/tenon joints. When applying from plastic tank, follow the Collano Easy Applico 2000 operating instructions.

Minimum press time

• 20 °C: > 10 minutes
• 50 °C: > 5 minutes
• 80 °C: > 2 minutes

Additional details

In contact with iron, adhesive may cause wood discoloration. Water-resistance of the seal (D4) is increased by adding 5% (by weight) of Collano hardener HR 910. Mix well with hardener. Mixture can be processed for 12 hours.

Clean-up

With water before adhesive has dried.

Packaging

• Plastic bottles 300 g and 800 g
• Plastic tanks 10 kg for Collano Easy Applico 2000
• Plastic pails 12 kg and 25 kg
• IBC containers 600 kg and 1'100 kg