Coco Asphalt Engineering 10-02 Asphalt Cutback Pavement Sealer

• Recommended for sealing asphalt driveways, parking lots, pathways and other asphalt surfaces.
• Also can be used as a protective coating for some metal and wood surfaces.

• Not resistant to gasoline, oil, or other petroleum products.
• Will not cure when applied over coal tar surfaces.

• Surface must be dry and free from all dirt, oil, grease and foreign matter.
• No priming is required. Minor oil spots or greasy areas must be treated with COCO SPOT-X Oil Spot Primer prior to application of 10-02 ASPHALT SEALER.
• Badly oil-damaged areas must me removed and patched with cold patch.
• Allow newly laid pavements and asphalt patches to cure for 90 days in warm weather before applying 10-02 ASPHALT SEALER.
• Do not apply if rain is expected or if the pavement surface is damp.
• Do not apply over coal tar surfaces.

• Apply by spray, brush, or squeegee.
• Avoid pooling.
• Do not dilute.
• Addition of gasoline or other thinners will alter the product and cause the cured film to discolor.
• Browning or other discolouration may also occur if the pavement surface contains excessive moisture.
• Use caution not to over-apply if applying by brush or squeegee - curing times are longer when application rates are high.
• Do not apply if the temperature is less than 15°C.
• Under favorable conditions, the sealer will be cured after 24 hours.
• Under marginal conditions (temperatures below 15°C, damp, cloudy weather) curing time will be extended and may take 7 days or more depending on the severity of the conditions.
• For best results, do not apply to hot pavement or when temperatures exceed 27°C.
• Do not open sealed surface to traffic until sealer has cured.

Any suitable safety solvent.