Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
Applications & Uses
- Application Method
- Cure Method
- Reducer & Clean Up
VM&P Naphtha
- Application Procedures
The surface must be clean, dry, and in sound condition. Remove all dirt, loose rust, and other foreign material in accordance with SSPC-SP2 to ensure adequate adhesion.
Application Method Spray Equipment Settings for Spray Airless Spray
- Approx. 50 - 70 lbs
- Pressure 15 - 19
- Fluid tip & air cap
Recommended Film Thickness min. 2.0mil Top Coat Not for use under 2 component topcoats
- Alkyd - 1 part
- Urethane - 1 part
- Epoxy
Coverage 902 sq ft (1 mil, 100% Efficiency) Welds Maybe weld thru with standard Welding procedures.
Properties
- Color
- Typical Properties
- Performance Properties
- Conditions
*The system tested (unless otherwise indicated) is steel prepared in accordance with SSPC-SP2, sprayed with one coat of ARMORHIDE AS SP 1000 GRAY PRIMER and allowed to air dry for 7 days.
| Value | Units | Test Method / Conditions | |
| Weight | 10.839 - 11.25 | per gal | - |
| Viscosity | 28 - 41 | s | Zahn #2 Signature Cup |
| Grind | 5.0 | - | Hegman |
| Weight Solids | 71.5 - 73.5 | % | - |
| Volume Solids | 49.8 - 50.8 | % | - |
| VOC as Supplied | 3.12 | lbs/gal | - |
| Gloss (60°) | 1.0 - 10.0 | ° | - |
| Dry Time (Tack Free) | 20.0 | min | - |
| Dry Time (Thru Dry) | 10.0 | h | - |
| Value | Units | Test Method / Conditions | |
| Salt Fog Resistance* | 150.0 | h | ASTM B117 |
| Pencil Hardness* | B | - | ASTM D3363 |
| Direct Impact Resistance* | 20.0 | in.lb | ASTM G14 |
| Cyclic Salt Fog U/V Exposure* | 500.0 | h | ASTM D5894 |
| Water Sensitivity* | No Blistering | - | ASTM D1308 |
| Humidity Resistance* | 96.0 | h | ASTM D4585 |
Regulatory & Compliance
- Regulatory & Compliance
- This product is designed to be applied directly to prepared steel surfaces and meets SSPC-Paint Specification No. 15.
- The product meets the performance requirements of TTP 664D-SSPC-Paint No. 25 as specified for use in SSPC Environmental Zone 1A and 1B.
- This product also meets the performance requirements of CISC/CPMA Standards 1-73a and 2-75.
Storage & Handling
- Remarks
- This product should be stored indoors at temperatures between 35 - 100 °F.
- It is also not recommended to paint on surfaces below 50°F.
- Adhesion problems may be experienced.
- This product can be welded through to yield sound welds.
- This primer can be recoated after 1 hour.